![]() ![]() If you're happy with how the print looks hit the "Save to Disk" button and save the G-code to your Printers SD card. ![]() Simplif圓D will bring up a model showing you information about the print. Once you have the settings that you want hit "Okay" and then "Prepare to Print".Ģ. This is also where you can change other settings like for supports, amount of infill, and layer resolution.Ģ. may be problems when the 3D printer software comes to slicing up the model for printing. Once you have the Model the way you want it hit the button that says "Edit Process Settings" and make sure that you have the Altair profile selected and also make sure you select the correct material that you want to use. The display grid has two settings - one for the thick lines. To center the print on the print bed all you have to do is go to "Edit" and then "Center and Arrange Models" or hit Ctrl+R.ġ. With Inventor a sketch plane can be used & geometry projected & extruded - not sure how to keep the same co-ordinate system trying to copy the workflow in Autocad. To orient the part on the bed how you want it to print all you have to do is go to "Edit" and then "Place Surface on Bed" or hit Ctrl+L and then select whatever side you want to lay flat on the bed.Ģ. Models imported from Inventor & Navisworks can be sizable - currently theses models are xrefs but when switched on performance is slow. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |